The installation of a manhole for water supply is necessary for routine inspections and repair of sections of the pipeline that are most at risk of leaks. The mine can be made of concrete, brick, plastic.

A caisson for a well can be made with your own hands from concrete rings, a brick, a metal or plastic barrel, or you can make a monolithic structure. It is important to take care of the tightness of the caisson in order to avoid flooding.

Triton plastic caissons are used for tying a well. Protect the source from freezing, pollution, reduce noise. A pump station with a hydraulic tank and automation can be located in the tank. The volume allows maintenance and repair work to be carried out without problems.

If there is water with fine sand coming from the well, you need to check the bottom filter and the mesh on the suction pipe. Also, the cause may be too powerful pumping equipment, which, with a decrease in flow rate, drives water from the bottom, or damage to the casing.

The timing of replacing the cartridge in the water filter depends on the number of residents and the intensity of water use. The instructions indicate the approximate periods of operation of the filter elements. A sign of contamination is a decrease in water productivity or a change in water quality for the worse.

To find out the depth of water for a well, you should use hydrogeological maps. In their absence, it is possible to navigate along the plants growing on the site, however, such observations do not give accurate data.

When choosing a location, the location of the well on the site must take into account the requirements of construction and sanitary standards. The hydraulic structure should be as far away as possible from the septic tank and other sources of pollution, it needs free access for maintenance.

Wells are cleaned of sludge using a bailer, pumping equipment or airlift method. If possible, you should invite professionals who have experience and all the necessary equipment. To prevent siltation, it is recommended to operate the source continuously, without prolonged downtime.

If muddy water comes from the well, it is necessary to check the tightness of the casing and the performance of the filters. With prolonged idle time, siltation of the bottom and walls begins. In this case, flushing the column under high pressure is required.

Before installing the submersible pump in the well, it is necessary to lay the pipeline, lead the electric cable, install the check valve. A strong silicone cord is recommended as a safety cable. It is forbidden to suspend the unit on the power cable.

If there is little water in the well, check the bottom of the source. Due to downtime or clogging of the filter element, the bottom may become silted. Additional hydraulic structures in one aquifer, as well as a too powerful pump that does not allow the source to be replenished, affect the well flow rate.