The water that flows in our apartments from taps can be of dubious quality. It contains many elements that may not be the best way to affect human health. That is why installing the filter is coarse ...

Equipment for water purification and water treatment is classified depending on the scope, quality of the initial liquid and the required volume of water for the consumer.

The well pump Aquarius, with proper installation and compliance with the rules of operation and maintenance, uninterruptedly supplies water to a private house. To select a model, you need to determine the required volume of fluid consumed, take into account the height of the water mirror and the length of the pipeline.

The filter for coarse or fine purification of hot water is not structurally different from devices for cold water supply, but the elements are made of materials resistant to high temperatures. When choosing filter elements, the quality of the tap fluid should be considered.

Buying a filter for a reverse osmosis system is the right step to achieve a balance in the composition of purified water. Thanks to the water mineralizer, after reverse osmosis, the liquid becomes close in composition to the natural position of the molecules. However, this water should not be abused and should not be used everywhere.

If the site has a high level of groundwater, or the climate zone is characterized by heavy rainfall, it is necessary to make a drainage system around the house. The relief, the end point of the effluent discharge, the necessary slope should be taken into account. Drainage can be underground and surface.

The method of cleaning water filters depends on their composition, device and design. Some items are subject to replacement only. Mesh cleaners are washed with water, for aragon cleaning with soda and lemon is suitable. In bulk structures, the filler is changed.

Filters for water purification Zepter work on the principle of reverse osmosis. Only water molecules and gas pass through the membrane. Filter elements should be changed on time so that the result meets expectations.

A water pressure increase pump for reverse osmosis systems is necessary for normal equipment performance if there is not enough pressure in the line. The device is built-in, consumes little electricity, runs silently.

The drilling clamp for tapping into a water pipe under pressure is a prefabricated module equipped with special nozzles and rotary connectors. It is mounted on polymer, cast-iron and steel water supply lines.

The maximum suction depth of the pumping station is an indicator that must be taken into account when choosing a model. As a rule, it is 8-10 meters. It is important to consider not only the level of the water mirror, but also the vertical sections of the water supply.